S_WipePixelateTransitions between two input clips by adding blocks of pixels of one clip onto another in a semi-random order. The Wipe Amount parameter should be animated to control the transition speed. Adjust the Edge Width and Chunky parameters for different pixelated patterns.In the Sapphire Transitions category.
Inputs:
|
|
Parameters:
-
Load Preset:
Push-button
.
Brings up the Preset Browser to browse all available presets for this effect.
-
Save Preset:
Push-button
.
Brings up the Preset Save dialog to save a preset for this effect.
-
Wipe Amount:
Default:
0,
Range:
0 to 1.
Determines the transition ratio between the From and To inputs, and would normally be animated from 0 to 1 to perform a complete transition. The curve controlling this parameter can be adjusted for more detailed control over the timing of the wipe.
-
Pixel Frequency:
Default:
20,
Range:
0.1 or greater.
Increase for smaller and more pixels, decrease for fewer and larger pixels.
-
Pixel Rel Width:
Default:
1,
Range:
0.01 or greater.
The relative horizontal size of the pixels. Increase for wide pixels, decrease for tall ones.
-
Chunky:
Default:
0,
Range:
0 or greater.
Increase to cause the pixels to be added with a more clustered ordering.
-
Seed:
Default:
0.23,
Range:
0 or greater.
Used to initialize the random number generator. The actual seed value is not significant, but different seeds give different results and the same value should give a repeatable result.
-
Edge Width:
Default:
1,
Range:
0.01 or greater.
The width of the transition area.
-
Angle:
Default:
0,
Range:
any.
The angle of the wipe direction in degrees. Use 0 for a wipe from left to right, 90 or -90 for a vertical wipe, 180 for a wipe from right to left.
